BS EN 10272: 2007 Stainless steel bars for pressure purposes (Eng)

30 стр. American Petroleum Institute, Fifth Edition, June 2007 This Recommended Practice (RP) provides guidelines for pressure testing steel pipelines for the transportation of gas, petroleum gas, hazardous liquids, highly volatile liquids or carbon dioxide. The RP provides guidance so that: a. Pipeline operators can select a pressure test suitable for the conditions under which the test will be conducted. This includes, but is not limited to, pi...

American Petroleum Institute (API) Temth Edition, November 1998. Addendum 2, November 2001. 240p. This standard covers material, design, fabrication, erection, and testing requirements for vertical, cylindrical, aboveground, closed- and open-top, welded steel storage tanks in various sizes and capacities for internal pressures approximating atmospheric pressure (internal pressures not exceeding the weight of the roof plates), but a higher interna...

This European Standard was approved by CEN on 3 September 1999. 54p. This European Standard specifies the requirements for flat products for pressure purposes made of stainless steels, including austenitic creep resisting steels, in thicknesses as indicated in Tables 6 to 9. The requirements in EN 10028-1 also apply.

This European Standard was approved by CEN on 18 September 2003. 12p. This European Standard specifies the nominal dimensions and the tolerances on dimensions and shape of hot-rolled finished square steel bars for general purposes

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This European Standard was approved by CEN on 5 September 1999. 24p. This Part of this European Standard specifies the technical delivery conditions for forgings for pressure purposes, made of ferritic and martensitic steels with specified elevated temperature purposes

This European Standard was approved by CEN on 8 November 1998. 10p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes, made of nickel steels, for use at low temperatures.

This European Standard was approved by CEN on 8 November 1998. Amendment A1:2000 was approved by CEN on 20 April 2001. 12p. This part of this European Standard specifies the technical delivery conditions of the types of forgings for pressure purposes, made of weldable fine-grain steels with high proof strength.

This European Standard was approved by CEN on 3 September 1999. 20p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes made of stainless steels, including creep resisting steels.

This European Standard was approved by CEN on 1 July 2004. 15p. This document specifies the composition, dimensions and mechanical properties of high carbon steel wire for reinforcing high pressure hoses. It is applicable to wire used as a multiple parallel wire braided or spirally wrapped reinforcement in a rubber or synthetic hose which is made to withstand relatively high bursting pressure.