• формат pdf
  • размер 37.72 МБ
  • добавлен 22 января 2012 г.
Frennet A., Bastin J.-M. (Eds.) Catalysis and Automotive Pollution Control III
Elsеvier Sciеnce, 1995. 940 p. ISBN:0444820191

These proceedings are taken from the Third Inteational Symposium (CAPoC3), held in Belgium, 1994, and are devoted to the use of catalysis for the depollution of exhaust gases of motor vehicles. It covers such areas as catalyst ageing and poisoning, and gasoline catalyst technologies.
These proceedings are based on the third of a series of symposia devoted to the use of catalysis for the depollution of exhaust gases of motor vehicles. Although catalysts have been used for this purpose for some thirty years, the subject is still very topical because of its economic impact. The increasing number of submitted, accepted and published papers amply attests to this fact.
Похожие разделы
Смотрите также

Blair Gordon P. Design and Simulation of Two-Stroke Engines

  • формат pdf
  • размер 52.57 МБ
  • добавлен 22 августа 2010 г.
Society of Automotive Engineers, 1996. 623 p. ISBN:1-56091-685-0 В учебнике: Проектирование и моделирование двухтактных двигателей (англ.) рассмотрена теория и конструкция двигателей. Оглавление. Терминология. Введение в двухтактные двигатели. Газоообмен в двухтактных двигателях. Сгорание в двухтактных двигателях. Компьютерное моделирование двигателей. Эмпирическая помощь для разработчика. Снижение расхода топлива и вредных выбросов в от...

Eastwood P. Particulate Emissions from Vehicles

  • формат pdf
  • размер 6.56 МБ
  • добавлен 19 июля 2011 г.
John Wiley & Sons Ltd, 2008. 512 p. ISBN:0470724552 The public health risks posed by automotive particulate emissions are well known. Such particles are sufficiently small to reach the deepest regions of the lungs; and moreover act as carriers for many potentially toxic substances. Historically, diesel engines have been singled out in this regard, but recent research shows the need to consider particulate emissions from gasoline engines as...

Guzzella L., Onder C.H. Introduction to Modeling and Control of Internal Combustion Engine Systems

  • формат pdf
  • размер 16.1 МБ
  • добавлен 15 декабря 2010 г.
Springer-Verlag, Berlin, Heidelberg, 2010. 354 р. ISBN:978-3-642-10774-0 Contents Introduction Mean-Value Models Discrete-Event Models Control of Engine Systems А Basics of Modeling and Control-Systems Theory B Case Study: Idle Speed Control C Combustion and Thermodynamic Cycle Calculation of ICEs References

Hiereth H., Prenninger P. Charging the Internal Combustion Engine

  • формат pdf
  • размер 7.72 МБ
  • добавлен 15 декабря 2010 г.
Springer-Verlag, Wien, 2007. 268 р. ISBN:978-3-211-33033-3 Powertrain Edited by Helmut List Contents Introduction and short history of supercharging Basic principles and objectives of supercharging Thermodynamics of supercharging Mechanical supercharging Exhaust gas turbocharging Special processes with use of exhaust gas turbocharging Performance characteristics of supercharged engines Operating behavior of supercharged engines in autom...

Martyr A.J., Plint M.A. Engine Testing. Theory and Practice

  • формат pdf
  • размер 2.95 МБ
  • добавлен 08 сентября 2010 г.
Elsevier, 2007, 459 стр. [Испытания ДВС. Теория и практика] This book brings together the large and scattered body of information on the theory and practice of engine testing, to which any engineer responsible for work of this kind must have access. Engine testing is a fundamental part of development of new engine and powertrain systems, as well as of the modification of existing systems. It forms a significant part of the practical work of many...

Mollenhauer Klaus, Tschoeke Helmut. Handbook of Diesel Engines

Справочник
  • формат pdf
  • размер 24.16 МБ
  • добавлен 27 октября 2010 г.
DOI 10.1007/978-3-540-89083-6 Library of Congress Control Number: 2010924045 Berlin, Heidelberg: Springer-Verlag, 2010. Справочник по дизельным двигателям (англ. ) Краткое содержание по разделам: Part I The Diesel Engine Cycle Part II Diesel Engine Engineering Part III Diesel Engine Operation Part IV Environmental Pollution by Diesel Engines Part V Implemented Diesel Engines Standards and Guidelines for Internal Combustion Engines

Stotsky A.A. Automotive Engines. Control, Estimation, Statistical Detection

  • формат pdf
  • размер 3.98 МБ
  • добавлен 24 декабря 2010 г.
Springer-Verlag Berlin Heidelberg, 2009. 215 р. ISBN:978-3-642-00163-5 Contents Part I Idle Speed Control, Adaptive Flow Estimation and Spline Interpolation Idle Speed Control with Estimation of Unmeasurable Disturbances Introduction Engine Model Problem Statement Control Design Observer Design for Disturbance Torque Td(t) Control Law Design for a Spark Advance Control Law Design for Throttle Stability Analysis of the System Simulati...

Tsuji H. (et al.) High Temperature Air Combustion: From Energy Conservation to Pollution Reduction

  • формат pdf
  • размер 5.84 МБ
  • добавлен 13 марта 2011 г.
CRC Press, 2003. 424 p. ISBN: 0849310369 Maximize efficiency and minimize pollution: the breakthrough technology of high temperature air combustion (HiTAC) holds the potential to overcome the limitations of conventional combustion and allow engineers to finally meet this long-standing imperative. Research has shown that HiTAC technology can provide simultaneous reduction of CO2 and nitric oxide emissions and reduce energy consumption for a spec...

Yamagata H. The Science and Technology of Materials in Automotive Engines

  • формат pdf
  • размер 6.88 МБ
  • добавлен 07 марта 2011 г.
CRC Press, 2005. 318 p. ISBN: 0849325854 This new book provides and introductory text on the science and technology of materials in automotive engines. It focuses on reciprocating engines, both four and two-stroke, with particular emphasis on their characteristics and the materials used in their construction. The books considers the engine in terms of each specific part: the piston, cylinder, camshaft valves, crankshaft, connecting rod and cata...

Zhao Hua (Ed). HCCI and CAI engines for the automotive industry

  • формат pdf
  • размер 7.23 МБ
  • добавлен 31 августа 2010 г.
CRC Press, Woodhead Publishing, 2007. 557 p. ISBN:978-1-4200-4459-1 This authoritative book provides an introductory text on the science and technology of materials used in automotive engines. It focuses on reciprocating engines, both four- and two-stroke, with particular emphasis on their characteristics and the types of materials used in their construction. The book considers the engine in terms of each specific part: the cylinder, piston, ca...