BS EN 10222-4: 1999+A1: 2001 Steel forgings for pressure purposes - Part 4: Weldable fine-grain steels with high proof strength (Eng)

This European Standard was approved by CEN on 1 April 2004. 28p. This European Standard specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized/normalized rolled delivery condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) in thickness ? 250 mm for grades S275, S355 and S420 and in thickness ? 200 mm for grade...

This European Standard was approved by CEN on 1 April 2004. 28p. This European Standard specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the thermomechanical rolled condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) in thickness ? 120 mm for flat products and in thickness ? 150 mm for long products

This European Standard was approved by CEN on 20 January 2003. 18p. This European Standard specifies requirements for flat products for pressure equipment made of weldable fine grain steels as specified in Table 1.

This European Standard was approved by CEN on 17 January 2003. 18p. This European Standard specifies the requirements for flat products for pressure equipments made of thermomechanically rolled steels as specified in Table 1.

This European Standard was approved by CEN on 17 January 2003. 16p. This European Standard specifies the requirements for flat products for pressure equipments made of quenched and tempered steels as specified in Table 1. The requirements in EN 10028-1 also apply.

This European Standard was approved by CEN on 3 September 1999. 54p. This European Standard specifies the requirements for flat products for pressure purposes made of stainless steels, including austenitic creep resisting steels, in thicknesses as indicated in Tables 6 to 9. The requirements in EN 10028-1 also apply.

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This European Standard was approved by CEN on 5 September 1999. 24p. This Part of this European Standard specifies the technical delivery conditions for forgings for pressure purposes, made of ferritic and martensitic steels with specified elevated temperature purposes

This European Standard was approved by CEN on 8 November 1998. 10p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes, made of nickel steels, for use at low temperatures.

This European Standard was approved by CEN on 3 September 1999. 20p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes made of stainless steels, including creep resisting steels.