BS EN 10222-5: 2000 Steel forgings for pressure purposes - Part 5: Martensitic, austenitic and austenitic-ferritic stainless steels. (Eng)

This European Standard was approved by CEN on 17 January 2003. 18p. This European Standard specifies the requirements for flat products for pressure equipments made of thermomechanically rolled steels as specified in Table 1.

This European Standard was approved by CEN on 3 September 1999. 54p. This European Standard specifies the requirements for flat products for pressure purposes made of stainless steels, including austenitic creep resisting steels, in thicknesses as indicated in Tables 6 to 9. The requirements in EN 10028-1 also apply.

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This European Standard was approved by CEN on 5 September 1999. 24p. This Part of this European Standard specifies the technical delivery conditions for forgings for pressure purposes, made of ferritic and martensitic steels with specified elevated temperature purposes

This European Standard was approved by CEN on 8 November 1998. 10p. This part of this European Standard specifies the technical delivery conditions of forgings for pressure purposes, made of nickel steels, for use at low temperatures.

This European Standard was approved by CEN on 8 November 1998. Amendment A1:2000 was approved by CEN on 20 April 2001. 12p. This part of this European Standard specifies the technical delivery conditions of the types of forgings for pressure purposes, made of weldable fine-grain steels with high proof strength.

18 стр. The European Standard EN 10246-10:2000 has the status of a British Standard July 1996 This Part of EN 10246 specifies the requirements for automatic electromagnetic testing of seamless and welded ferromagnetic steel tubes, with the exception of submerged arc-welded (SAW) tubes, for verification of hydraulic leak-tightness. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter greater than or equal to 4 mm...

16 cтр. The European Standard EN 10246-2:2000 has the status of a British Standard February 2000 This part of EN 10246 specifies requirements for automatic eddy current testing of seamless and welded austenitic and austenitic-ferritic steel tubes with the exception of submerged arc-welded (SAW) tubes for verification of hydraulic leak-tightness. The standard specifies acceptance levels, calibration procedures and gives guidance on the limitations...

This European Standard was approved by CEN on 23 August 2007. 38p. This document specifies the technical delivery conditions for hot and cold formed stainless steel bars for the construction of pressure equipment supplied in accordance with one of the process routes and surface finishes listed in Table 5.

Европейский стандарт "Неразрушающие испытания - Ультразвуковой контроль листового проката из аустенитных и аустенитно-ферритных нержавеющих сталей размером 6 мм или более (методом отраженных волн)" утвержден в сентябре 2001г.