BS EN 10244-1: 2009 Steel wire and wire products - Non-ferrous metallic coatings on steel wire - Part 1: General principles (Eng)

This European Standard was approved by CEN on 25 November 2006. 20p. This European Standard specifies the general technical delivery conditions for all steel products covered by EN 10079 with the exception of steel castings and powder metallurgical products.

This European Standard was approved by CEN on 13 January 2007. 48p, This European Standard defines terms for steel products according to: a) shape and dimensions; and b) appearance and surface condition.

This European Standard was approved by CEN on 26 October 1997. Amendment A1 was approved by CEN on 14 March 2002. 18p. This Part of this European Standard specifies the general technical delivery conditions for open die steel forgings, ring rolled products and forged bars for pressure purposes

This European Standard was approved by CEN on 20 December 2008. 20p. This part of this European Standard specifies the requirement for coating mass, other properties and testing of zinc and zinc alloy coatings on steel wire and steel wire products of circular or other section.

14 cтр. The European Standard EN 10246-12:2000 has the status of a British Standard February 2000 This part of EN 10246 specifies the requirements and the acceptance levels for magnetic particle inspection of seamless and welded ferromagnetic steel tubes for the detection of surface imperfections. This part of EN 10246 is to be used for the detection of surface imperfections on the entire or any part of the outer surface of tubes, excluding the e...

16 стр. The European Standard EN 10246-14:1999 has the status of a British Standard November 1999 This Part of EN 10246 specifies requirements for automatic ultrasonic testing of seamless and welded steel tubes, with the exception of submerged arc welded (SAW) tubes, for the detection of laminar imperfections. The standard specifies acceptance levels and calibration procedures. NOTE : An alternative test method for the detection of laminar imperf...

18 стр. The European Standard EN 10246-10:2000 has the status of a British Standard July 1996 This Part of EN 10246 specifies the requirements for automatic electromagnetic testing of seamless and welded ferromagnetic steel tubes, with the exception of submerged arc-welded (SAW) tubes, for verification of hydraulic leak-tightness. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter greater than or equal to 4 mm...

16 стр. The European Standard EN 10246-6:1999 has the status of a British Standard November 1999 This Part of EN 10246 specifies the requirements for automatic ultrasonic shear wave testing of seamless steel tubes for the detection of transverse imperfections. The standard specifies acceptance levels and calibration procedures. This Part of EN 10246 is applicable to the inspection of tubes with an outside diameter equal to or greater than 10 mm....

This European Standard was approved by CEN on 1 July 2004. 15p. This document specifies the composition, dimensions and mechanical properties of high carbon steel wire for reinforcing high pressure hoses. It is applicable to wire used as a multiple parallel wire braided or spirally wrapped reinforcement in a rubber or synthetic hose which is made to withstand relatively high bursting pressure.

This European Standard was approved by CEN on 23 May 2002. Amendment A1 was approved by CEN on 12 May 2005. 18p. This European Standard specifies the requirements for industrial piping systems and supports, including safety systems, made of metallic materials (but initially restricted to steel) with a view to ensure safe operation.