DIN 51502 - Designation of lubricants and marking of lubricant containers, equipment and lubricating points (Eng)

American Petroleum Institute (API) Fourth Edition, September 1995. 23p. This publication covers the safety aspects to be considered when hot tapping, or when welding without hot tapping on in-service piping or equipment. It is not a substitute for job planning. A detailed, written procedure for hot tapping and welding should be prepared or reviewed before starting each job to ensure that all proper steps are taken.

67 стр. American Petroleum Institute, Second Edition, December, 1997 This specification is formulated to provide for the availability of safe and functionally interchangeable drill through equipment utilized for drilling for oil and gas. Technical content provides requirements for performance, design, materials, tests and inspection, welding, marking, handling, storing, and shipping. This specification does not apply to field use or field testing...

148 стр. EIGHTH EDITION, DECEMBER 2008 This standard applies to the sizing and selection of pressure relief devices used in refineries and related industries for equipment that has a maximum allowable working pressure of 15 psig (103 kPag) or greater. The pressure relief devices covered in this standard are intended to protect unfired pressure vessels and related equipment against overpressure from operating and fire contingencies. This standard...

167 стр. API STANDARD 618 FOURTH EDITION, JUNE 1995 This standard covers the minimum requirements for reciprocating compressors and their drivers used in petroleum, chemical, and gas industry services for handling process air or gas with either lubricated or nonlubricated cylinders. Compressors covered by this standard are of mod- erate-to-low speed and in critical services. Also covered are related lubricating systems, controls, instrumentation,...

This Part of the European Standard specifies requirements for the inspection during construction, documentation and marking of shell boilers as defined in EN 12953-1

This Part of this European Standard specifies requirements for safety related equipment for shell boilers as defined in EN 12953-1, irrespective of the degree of supervisions.

This European Standard was approved by CEN on 29 April 2002. 8p. This European Standard defines terms and definitions of parties involved in the design, manufacture, testing and inspection of pressure equipment and assemblies addressed by the European Directive 97/23/EC

На английском и французском языках. 26 стр. Electrical equipment for measurement, control and laboratory use – EMC requirements – Part 2-4: Particular requirements – Test configurations, operational conditions and performance criteria for insulation monitoring devices according to IEC 61557-8 and for equipment for insulation fault location according to IEC 61557-9 Mat?riel ?lectrique de mesure, de commande et de laboratoire – Exigences relatives...

На английском и французском языках. 50 стр. Electrical safety in low voltage distribution systems up to 1 000 V a.c. and 1 500 V d.c. – Equipment for testing, measuring or monitoring of protective measures – Part 9: Equipment for insulation fault location in IT systems S?curit? ?lectrique dans les r?seaux de distribution basse tension de 1 000 V c.a. et 1 500 V c.c – Dispositifs de contr?le, de mesure ou de surveillance de mesures de protection –...