BS EN 12072: 2000 Welding consumables - Wire electrodes, wires and rods for arc welding of stainless and heat-resisting steels - Classification (Eng)

This standard American Welding Society (AWS). 1997. 19p. This specification prescribes requirements for the classification of bare nickel and nickel-alloy welding electrodes, strip electrodes, and welding rods. It includes those compositions where the nickel content exceeds that of any other element.

This standard American Welding Society (AWS). 1990. 18p. This specification prescribes requirements for the classification of the following: (a) Rods for oxyfuel gas welding; (b) Electrodes for gas metal arc welding; (c) Electrodes for flux cored arc welding; (d) Electrodes for shielded metal arc welding.

This standard American Welding Society (AWS). 1995. 40p. This specification prescribes requirements for the classification of stainless steel electrodes for flux cored arc welding and flux cored rods for root pass welding with the gas tungsten arc process.

This standard American Welding Society (AWS). 1993. 25p. This specification prescribes requirements for the classification of bare stainless steel wire, strip, composite metal cored, and stranded welding electrodes and rods.The chromium content of these filler metals is not less than 10.5 percent and the iron content exceeds that of any other element.

This European Standard was approved by CEN on 14 October 2004. 32p. This document describes the basic verification tests, the testing methods, the amount of testing and the requirements for the qualification of wire electrodes, wires and rods for welding of aluminium.

This European Standard was approved by CEN on 2 January 2004. 16p. This standard specifies requirements for classification of electrode-flux combinations and all-weld metal in the as-welded condition for submerged arc welding of non alloy and fine grain steels with a minimum yield strength of up to 500 MPa. Classification can be made with solid wire electrodes or tubular cored electrodes. One flux may be classified with different electrodes. The...

This European Standard was approved by CEN on 1996-02-12. 14p. This standard applies to fluxes for the submerged arc welding of non-alloyed, low alloy and high alloy steels such as stainless and heat resisting steels and of nickel and nickel alloys using wire electrodes and strip electrodes.

The text of ISO 636:2004 has been prepared by Technical Committee ISO/TC 44 Welding and allied processes of the International Organization for Standardization (ISO) and has been taken over as EN ISO 636:2008 by Technical Committee CEN/TC 121 Welding the secretariat of which is held by DIN. This European Standard was approved by CEN (EUROPEAN COMMITTEE FOR STANDARDIZATION) on 5 April 2008 This International Standard specifies requirements for clas...